HP XM600 hp kayak xm600, installing and replacing hardware parts in your pc wo - Page 28

Replacing the System Board, Removing the, System Board

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Installing and Replacing Hardware Parts in Your PC Workstation Replacing the System Board Removing the System Board Replacing the System Board 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover and front bezel (refer to page 3 for these instructions). 3 Remove the HP UltraFlow Airflow Guide (refer to page 4 for instructions). 4 Disconnect any cables attached to the system board. 5 Move the front access cage forward (described on page 18). 6 Remove the main memory, processor and any accessory cards from the old system board (described in this chapter). 7 Remove the screw located on the rear panel near the AGP slot. 8 Lift the system board out, being careful not to damage the PC's rear connectors. 9 Unclip the retaining bracket from the system board. This bracket must be re-installed on the new system board (refer to the diagram on the following page).  ò 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
28
Replacing the System Board
Removing the
System Board
1
Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2
Remove the PC Workstation’s cover and front bezel (refer to page 3 for
these instructions).
3
Remove the HP UltraFlow Airflow Guide (refer to page 4 for
instructions).
4
Disconnect any cables attached to the system board.
5
Move the front access cage forward (described on page 18).
6
Remove the main memory, processor and any accessory cards from the
old system board (described in this chapter).
7
Remove the screw located on the rear panel near the AGP slot
.
8
Lift the system board out, being careful not to damage the PC’s rear
connectors.
9
Unclip the retaining bracket from the system board. This bracket must
be re-installed on the new system board (refer to the diagram on the
following page).
ò