HP Xw460c HP BladeSystem c7000 Enclosure Setup and Installation Guide - Page 31

Installing blades

Get HP Xw460c - ProLiant - Blade Workstation PDF manuals and user guides View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

To install a power supply: 1. Slide the HP BladeSystem Insight Display to the right or left to gain access to all power supply bays. 2. Open the power supply bracket. 3. Insert the power supply into the enclosure, and close the bracket. Check the power supply LEDs (on page 14) to determine the status of the power supply. To calculate how many power supplies are needed, see the HP BladeSystem Power Sizer (http://www.hp.com/go/bladesystem/powercalculator). Installing blades The c7000 enclosure is divided into four quadrants by the vertical support metal work. Within each quadrant, a removable divider supports half-height blades. To install a full-height blade in any quadrant, this divider must be removed. Therefore, a quadrant can only contain either full-height blades or halfheight blades. Installation 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
Installation 31
To install a power supply:
1.
Slide the HP BladeSystem Insight Display to the right or left to gain access to all power supply bays.
2.
Open the power supply bracket.
3.
Insert the power supply into the enclosure, and close the bracket.
Check the power supply LEDs (on page
14
) to determine the status of the power supply.
To calculate how many power supplies are needed, see the HP BladeSystem Power Sizer
(
).
Installing blades
The c7000 enclosure is divided into four quadrants by the vertical support metal work. Within each
quadrant, a removable divider supports half-height blades. To install a full-height blade in any quadrant,
this divider must be removed. Therefore, a quadrant can only contain either full-height blades or half-
height blades.