HP Xw460c HP BladeSystem c7000 Enclosure Setup and Installation Guide - Page 36
Creating a full-height device bay blank, with the contents of the full-height device shipping box.
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
3. Push the device bay shelf back until it stops, lift the right side slightly to disengage the two tabs from the divider wall, and then rotate the right edge downward (clockwise). 4. Lift the left side of the device bay shelf to disengage the three tabs from the divider wall, and then remove it from the enclosure. Creating a full-height device bay blank 1. Obtain the coupler plate: o If you are using a device bay blank that came with the enclosure, the coupler plate can be found with the contents of the full-height device shipping box. o If you are using a device bay blank that you purchased as an option, remove the coupler plate from inside the blank. Installation 36
Installation 36
3.
Push the device bay shelf back until it stops, lift the right side slightly to disengage the two tabs from
the divider wall, and then rotate the right edge downward (clockwise).
4.
Lift the left side of the device bay shelf to disengage the three tabs from the divider wall, and then
remove it from the enclosure.
Creating a full-height device bay blank
1.
Obtain the coupler plate:
o
If you are using a device bay blank that came with the enclosure, the coupler plate can be found
with the contents of the full-height device shipping box.
o
If you are using a device bay blank that you purchased as an option, remove the coupler plate
from inside the blank.