HP Z3200ps HP Designjet Z3200 Photo Printer Series - Setup Poster [English] - Page 1

1.2 set up troja Asia NEW.indd 1 HP Designjet Z2100, Z3200 and Z3200ps Photo Printer Series Assembly Instructions © 2008 Hewlett-Packard Company Inkjet Commercial Division Avenida Graells 501 · 08174 Sant Cugat del Vallès Barcelona · Spain All rights reserved Printed in Germany · Imprimé en Allemagne · Stampato in Germania 1 Read these instructions carefully... What you will need for this procedure • Because the printer is heavy, you may need three people to unpack it. When more than one person is needed, this symbol is displayed. • To assemble the printer you will need at least 1 x 2 m (40 x 80 in) of empty floor space. *Whenever you see this icon, you can find an animation illustrating the procedure on the HP Start-Up Kit DVD. 2 Printer working area Before you start unpacking, consider where you are going to put the assembled printer. You should allow some clear space on all sides of the printer box. The recommended clearances are shown in the illustration above. Note: If your printer is 24-in without stand, remove the printer box and the accessories box, place the printer on a table and remove the desiccant bag from below the printer. Then go to step 32. * 26/06/2008 11:16:04 AM