HP Z620 HP Workstations - CRU Dataport DX115 kit installation - Page 11
HP Z620 Manual
View all HP Z620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
4. Remove and discard the counter-sunk shipping screw at the side of the DX115 case. Figure 8 Removing the shipping screw 5. Install four (black) M3 x 5mm screws (supplied in the kit) in the lower four mounting holes of the DX115 case. Spare M3 screws supplied with your workstation are mounted on its chassis near the optical bay. Figure 9 Installing the guide screws 6. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place. Figure 10 Installing the DX115 unit ENWW Step 2-Installing the DX115 case into the optical drive bay 7
4.
Remove and discard the counter-sunk shipping screw at the side of the DX115 case.
Figure 8
Removing the shipping screw
5.
Install four (black) M3 x 5mm screws (supplied in the kit) in the lower four mounting holes of the
DX115 case. Spare M3 screws supplied with your workstation are mounted on its chassis near the
optical bay.
Figure 9
Installing the guide screws
6.
Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 10
Installing the DX115 unit
ENWW
Step 2—Installing the DX115 case into the optical drive bay
7