HP Z620 HP Workstations - CRU Dataport DX115 kit installation - Page 12

HP Z620 Manual

Get HP Z620 PDF manuals and user guides View all HP Z620 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

7. Rotate the drive cage to its upright position. Figure 11 Rotating the drive cage up 8. If the cables are not already routed and attached to the system board: a. b. Connect the SATA data cable to the system board connector labeled SATA1. Route the data cable through the cable guides to keep the data cable from being pinched by the drive cage when raising or lowering it. One guide is located on the bottom side of the drive cage. The other is part of the chassis frame under the drive cage. Route the data cable through these guides before connecting it to the optical drive. Figure 12 Routing the drive cable 8 CRU Dataport DX115 kit installation ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
7.
Rotate the drive cage to its upright position.
Figure 11
Rotating the drive cage up
8.
If the cables are not already routed and attached to the system board:
a.
Connect the SATA data cable to the system board connector labeled SATA1.
b.
Route the data cable through the cable guides to keep the data cable from being pinched by
the drive cage when raising or lowering it. One guide is located on the bottom side of the
drive cage. The other is part of the chassis frame under the drive cage. Route the data cable
through these guides before connecting it to the optical drive.
Figure 12
Routing the drive cable
8
CRU Dataport DX115 kit installation
ENWW