HP Z620 HP Workstations - CRU Dataport DX115 kit installation - Page 16
HP Z620 Manual
View all HP Z620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
4. Install one (supplied) 6-32 x 1/4 in. screw (silver) for each DX115 unit for shipping support. CAUTION: Failure to install the shipping screw might result in damage to the removable hard drive system. Figure 19 Installing the shipping support screw HP Z600 and HP Z800 computers 1. For HP Z800 computers: ● ● 2. 3. Remove the airflow guide to enable access to the optical bays. Remove the card support to enable access to the system board connectors. Remove and discard the counter-sunk shipping screw at the side of the DX115 case. See Figure 8 Removing the shipping screw on page 7. Lift and hold the drive release latch at the green touch point (1) while sliding the DX115 case into the bay (2). When the front of the drive is near its final position, release the latch, but continue to slide the drive inward until the latch closes and engages the drive. Figure 20 Installing the DX115 case 12 CRU Dataport DX115 kit installation ENWW