HP rp5400 User Guide - HP rp5400 Family of Servers - Page 153
Core I/O Removal, Remove all cables attached to the Core I/O card at the rear bulkhead.
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Removing and Replacing Components Individual Component Remove/Replace Instructions Core I/O Removal rp54xx Core I/O functions are contained on the GSP revision A/B and LAN/SCSI cards. Both cards are located on the PCI Backplane in the side service bay. The LAN/SCSI card is in I/O slot 1 and the GSP revision A/B card is in I/O slot 2. Before removing either of the Core I/O cards from the server, perform the following tasks: • Power down the server. • Detach all power cords from the server. To remove a Core I/O card from the server, perform the following steps: 1. Remove all cables attached to the Core I/O card at the rear bulkhead. NOTE Be sure to label the cables before removing them. 2. Disconnect any ribbon cable connectors attached to the Core I/O card in the side service bay. 3. Grasp the edge of the Core I/O card and pull it out of the server. The following graphic shows both Core I/O cards in the side service bay. Chapter 7 139