HP t5400 Troubleshooting Guide: HP t5400 Thin Client - Page 17

Removing and Replacing the Side Access Panel, Removing the Side Access Panel - drivers

Get HP t5400 - Thin Client PDF manuals and user guides View all HP t5400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

9. Load any necessary drivers. NOTE: You can download select hardware drivers from HP. Go to http://www.hp.com and search for your specific thin client model. 10. Reconfigure the thin client, if necessary. Removing and Replacing the Side Access Panel Removing the Side Access Panel WARNING! Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To remove the access panel: 1. Lay the unit flat on a stable surface with the right side up and the left side down. 2. Remove the two screws that secure the access panel to the chassis (1). 3. Slide the access panel about 8.3 mm (1/3 inch) toward the rear of the unit (2), and then lift the access panel up and off the unit (3). Figure 2-1 Removing the side access panel Removing and Replacing the Side Access Panel 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
9.
Load any necessary drivers.
NOTE:
You can download select hardware drivers from HP. Go to
and
search for your specific thin client model.
10.
Reconfigure the thin client, if necessary.
Removing and Replacing the Side Access Panel
Removing the Side Access Panel
WARNING!
Before removing the side access panel, ensure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove the access panel:
1.
Lay the unit flat on a stable surface with the right side up and the left side down.
2.
Remove the two screws that secure the access panel to the chassis (1).
3.
Slide the access panel about 8.3 mm (1/3 inch) toward the rear of the unit (2), and then lift the
access panel up and off the unit (3).
Figure 2-1
Removing the side access panel
Removing and Replacing the Side Access Panel
9