HP t5400 Troubleshooting Guide: HP t5400 Thin Client - Page 49
No Video, Part 3, Caution - power supply
View all HP t5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
No Video, Part 3 No Video Part 2 continued No Video Part 3 Turn off power, disconnect power cord, and open the computer. Reseat flash, then clear CMOS by removing and replacing the battery. Caution: Power is continuous to the system board and power supply even when the power switch is turned off. To prevent damage to the unit, disconnect the power cord from the power source or the unit before beginning disassembly procedures. Replace cover and power cord, then restart computer. Video OK, computer starts? Same No symp- No toms? CMOS checksum error defaults loaded Yes F1-CMOS checksum errordefaults loaded Yes Done Yes No Turn off the computer and disconnect power. Replace components in system one at a time starting with Flash. Test system after each replacement for video or beeps. Go to next page t5000 Troubleshooting Flow Chart No Video, Part 4 Troubleshooting 41