Hitachi C10LA Instruction Manual - Page 12

English Assembly the rear table rail (Fig. B-2) 6. Attach the middle plug (1) to the rear table rails (2). 7. Place the rear table rails on the saw table, aligning with the holes in each rail. 8. Place the bolts (3) and tread in the holes; tighten the bolts and check the alignment again. Fig. B-2 3 BLADE RAISING HANDWHEEL (FIG. D) Thread the blade handwheel handle (1) into blade raising handwheel (2) and tighten the nut (5). BLADE TILTING HANDWHEEL (FIG. D) Thread the blade handwheel handle (3) into blade tilting handwheel (4) and tighten the nut (5). Fig. D 2 1 5 2 1 4 3 ASSEMBLY THE REAR TABLE EXTENSION (FIG. C) NOTE: The maximum load for the rear table extension is 30 kg. 1. Insert the support rods (1) into the slot on the body shell. Place screws (2) and tighten. 2. Attach the rear table extension (3) to the support rods (1). Place screws (4) and tighten. 3. Place the screws (9) to the slot of the rear table reails (8). 4. Attach the side cover (10) to the rear table reails (8). 5. Tighten the nuts (7). 6. Align the triangle (5) on the rear table extension and the middle plug (6). 7. Loosen the nuts (7) and screws (4) to adjust the rear table extension (3) for alignment. Fig. C 4 5 6 8 9 3 7 1 2 10 BLADE GUARD ASSEMBLY (FIG. E, F) WARNING To avoid injury from an accidental start, make sure the switch is in the OFF position and the plug is disconnected from the power source outlet. • When installing the blade guard, cover the blade teeth with a piece of folded cardboard to protect yourself from possible injury. • Never operate this machine without the safety guard in place for all through sawing operations. Installing the blade guard assembly (Fig. E) 1. Remove the table insert. 2. With the blade elevation handwheel (1), raise the blade to the maximum height. 3. Loosen the blade lock handle (2) do not pull on handle just turn and move the handwheel (1) to 45° on the bevel scale. 4. Tighten the bevel lock handle. 5. Locate the splitter assembly mounting bracket (3) at the rear of the blade. 6. Cover the blade teeth with a folded cardboard or position the plastic blade guard over the blade to protect your hands. 7. Place the two kickback pawls (4) toward the rear of the table, and align the splitter mounting holes to the holes in the bracket. 8. Place the flat washers onto the blade guard lock bolt and thread the bolt (5) into the the mounting hole, then tighten securely. 9. Return the blade to 90º and replace the table insert. - 12 -