Honeywell 3800ISR050E User Manual - Page 47
Good Read Delay, User-Specified Good Read Delay, Trigger Modes, Manual/Serial Trigger
![]() |
View all Honeywell 3800ISR050E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Good Read Delay This sets the minimum amount of time before the scanner can read another bar code. Default = No Delay. * No Delay Medium Delay (1000 ms) Short Delay (500 ms) Long Delay (1500 ms) User-Specified Good Read Delay If you want to set your own length for the good read delay, scan the bar code below, then set the delay (from 0-30,000 milliseconds) by scanning digits from the inside back cover, then scanning Save. User-Specified Good Read Delay Trigger Modes Manual/Serial Trigger You can activate the scanner either by pressing the trigger, or using a serial trigger command (see Trigger Commands on page 11-4). When in manual trigger mode, the scanner scans until a bar code is read, or until the trigger is released. When in serial mode, the scanner scans until a bar code has been read or until the deactivate command is sent. In serial mode, the scanner can also be set to turn itself off after a specified time has elapsed (see Read Time-Out, which follows). * Manual/Serial Trigger 3800i/3800r User's Guide 3 - 3
![](/manual_guide/products/honeywell-3800isr050e-user-manual-549efa7/47.png)