Honeywell 3800ISR050E User Manual - Page 52

Aimer Beam Time-Out (Aimer Beam option only) Aimer Beam Time-Out powers down the aimer beam after a time-out if the trigger is still pulled and there isn't a valid decode. Scan the bar code below, then set the time-out by scanning digits (from 0 - 240,000 ms) from the Programming Chart inside the back cover of this manual and then scan Save. Default = 0 (no time-out) Time-Out Duration Centering Window Use the centering feature to narrow the scanner's field of view so the scanner reads only the bar code you want. When centering is turned on, the scanner only reads codes that intersect or are contained within the centering window you set up. At least part of a bar code must be within the window to be decoded or output by the scanner. To change the left or right edge of the centering window, scan Centering On, then scan one of the following bar codes. Then scan the percent you want to shift the centering window using digits on the inside back cover of this manual. Scan Save. Default Centering = 40% for Left, 60% for Right. Centering On Left of Centering Window * Centering Off Right of Centering Window 3 - 8 3800i/3800r User's Guide