Honeywell 3800ISR050E User Manual - Page 57

The breakdown of the command line is shown below: SEQBLK sequence editor start command 62 code identifier for Code 39 0011 Code 39 code length (9) plus CR suffix (2) = 11 41 start character match for Code 39, 41h = "A" FF termination string for first code 6A code identifier for Code 128 0012 Code 128 code length (10) plus CR suffix (2) = 12 42 start character match for Code 128, 42h = "B" FF termination string for second code 69 code identifier for Code 93 0011 Code 93 code length (9) plus CR suffix (2) = 11 43 start character match for Code 93, 43h = "C" FF termination string for third code Multiple Symbols Note: This feature does not work when the scanner is in Low Power mode. When this programming selection is turned On, it allows you to read multiple symbols with a single pull of the scanner's trigger. If you press and hold the trigger, aiming the scanner at a series of symbols, it reads unique symbols once, beeping (if turned on) for each read. The scanner attempts to find and decode new symbols as long as the trigger is pulled. When this programming selection is turned Off, the scanner will only read the symbol closest to the aiming beam. On * Off No Read With No Read turned On, the scanner sends an "NR" to the host if you pull and release the trigger without reading a code (e.g., bad bar code). If No Read is turned Off, the "NR" will not be sent to the host. On * Off 3800i/3800r User's Guide 3 - 13