Hoover F5917900 Owners Manual - Page 10

Step on handle release pedal and lower handle until it rests on the floor. If cleaning stairs or upholstery, remove hose by reversingprocedure as shown on pages 12 and13. Rotate recovery tank latches (E) outward (one on each side of tank). Lift tank off of carpet cleaner and carry it to a sink or drain. Replace tank and press down to ensure that it is properly seated in place. Rotate latches (E) (one on each side of tank) inward to lock tank in place. To continue cleaning stairs or upholstery, replace hose as shown on pages 12 and 13. . Raise handle to upright position and replace upper clean solution tank. If no color change is visible, spray Spot and Stain Spray Cleaner onto spots and traffic areas. Wait at least ten minutes. Use your SteamVacTM carpet cleaner to pick up Spot and Stain Spray Cleaner and spot. Repeat until spot is removed; carefully scrub with a household scrub brush if necessary. Do not saturate carpet or upholstery with Spot and Stain Spray Cleaner. if you do not have access to the Spot and Stain Spray Cleaner, double the amount of HOOVER Carpet/Upholstery Detergent (use 2 capfuls or 10 oz. per 1 gallon) in the clean solution tank. No cleaning solution removes all stains from all carpets. Stain removal varies 10 Unlatch back part of tank lid and remove lid. Empty tank. Pour dirty water out from the rear of the tank (F). Before you begin cleaning a. Vacuum thoroughly - For carpet, use a vacuum cleaner with an agitator for best results. Vacuum upholstery with a vacuum cleaner with cleaning tool attachments. Use a crevice tool to reach into tufts and folds Do not use the SteamVac TM carpet cleaner as a dry vacuum cleaner. b. For upholstery, check cleaning code - Use your HOOVER SteamVac TM carpet cleaner only if the upholstery fabric is marked with a "W" (for "wet" clean) or "S/W" (for "solvent/dry" or "wet" clean). Do not clean fabric marked "S" ("sol= vent/dry" clean only). If your upholstery does not have a code, seek professional assistance. c. Test for colorfastness =Mix detergent and water according to the instruc- with the type of spill, time elapsed before removal, carpet material, and carpet type. f. To prevent staining, use plastic or aluminum foil to protect wood or metal surfaces from possible water spray. g. To avoid wetting and possible damage to wood floors underneath area rugslcarpet, either move area rugs/carpet to a non-wood bare floor surface o_zprlace waterproof material (e.g. plastic) underneath them before cleaning. See pages 1land 12 for instructions on various cleaning tasks. *Available at additional cost if not included with your model. The lid replaces in a hinge-like manner. Position the front of lid under tabs (G) on front of tank. Rotate lid down onto tank. Make sure that the lid is secure on all sides before placing tank on cleaner. For full suction, it is important that the recovery tank lid is prop= erly secured before cleaning. tions under "Fill clean solution tank" on pages 8 and 9. Wet a white absorbent cloth with the solution. In a small, hidden area, gently rub the surface with the dampened cloth. Wait ten minutes and check for color removal or bleed with white paper towel or cloth. If surface has more than one color, check all colors. d. When cleaning entire floor, move furniture out of area to be cleaned (may not be necessary if only high traffic areas are to be cleaned). For furniture too heavy to move, place aluminum foil or wax paper under legs. This will prevent wood finishes from staining carpet. Pin up furniture skirts and draperies. e. Pretreat spots and heavy traffic areas with HOOVER@ Spot and Stain Spray Cleaner*= Test Spot and Stain Spray Cleaner for colorfastness by first spraying it on a hidden area; wait ten minutes and blot with white paper towels or cloth. Afler cleaning a. Allow carpet or upholstery to dry. To help prevent matting and resoiling the carpet, keep children and pets away from surface until it is completely dry. If it is necessary to walk on damp carpet, place towels or white cloths on the traffic areas. If furniture must be replaced before the carpet is dry, use plastic or aluminum foil pads under legs of furniture so metal slides or wood finishes will not stain the carpet. b. If desired, the carpet may be rinsed. Rinsing is not necessary for cleaning, but it may improve the surface's appearance after it is dry.