Hoover F5917900 Owners Manual - Page 15

Removab|e, brushes

Page 15 highlights

Make no more than 2 passes with the solution over any one area to prevent over=wetting and damage to fabric. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. 11. Empty recovery tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic shut-off", page 8). 10.Forheavilysoiledareas,it may be necessaryto repeathecleaning processM. akecrisscrossingstrokes totheoriginapl attern;overlapeach pass. When finished cleaning, follow "After cleaning" instructions on pages 10 and 11 and "After using tool" instructions on pages 13 and 14. Removab|e brushes Your carpet cleaner is equipped with removable brushes for easy cleaning. To remove brushes Disconnect cleaner from electrical outlet. To prevent possible leaking, remove clean solution tank and recovery tank. Set tanks aside. Press handle release pedal to lower handle. Turn cleaner over so bottom is facing up. Grasp inner portion of brush (A) and pull brush assembly out slightly to reveal latches (B). C Press all four latches (B) and pull brush block out. The brushes can be cleaned under running water. To replace brushes Align posts (C) on both ends of brush assembly with slots (D) in cleaner housing. Make sure that square post (E) also aligns with square hole (F). Turn brushes slightly until post fits easily into hole. _L_TS_J Press brush assembly firmly to snap into place. Continued -_ 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

10.Forheavilysoiledareas,itmay
benecessary
to repeathecleaning
process.
Makecrisscrossing
strokes
totheoriginal
pattern;overlapeach
pass.
Make
no more
than 2
passes
with
the
solution
over
any
one
area to
prevent
over=wetting
and damage
to fabric.
If additional
cleaning
is necessary,
wait until the upholstery
is complete-
ly dry before using the tool again.
11. Empty
recovery
tank when the
motor sound becomes
higher
pitched
and there is a loss in suction
(see "Automatic
shut-off", page 8).
When finished
cleaning,
follow "After
cleaning"
instructions
on pages 10
and 11 and "After using tool" instruc-
tions on pages 13 and 14.
Removab|e
brushes
Your carpet
cleaner
is equipped
with removable
brushes for easy
cleaning.
To
remove
brushes
Disconnect cleaner from electrical
outlet.
To prevent possible
leaking,
remove
clean solution tank and recovery
tank. Set tanks aside.
Press handle
release pedal to lower
handle. Turn cleaner over so bottom
is facing
up.
Grasp
inner portion of brush (A) and
pull brush assembly
out slightly
to
reveal latches (B).
Press all four latches (B) and pull
brush block out. The brushes
can
be cleaned
under running
water.
C
To
replace
brushes
Align posts (C) on both ends of
brush assembly
with slots (D) in
cleaner
housing.
Make sure that square post (E) also
aligns with square hole (F). Turn
brushes slightly
until post fits easily
into hole.
.................
_L_TS_J
Press brush assembly
firmly
to snap
into place.
Continued
-_
15