Hoover FH40010B Manual - Page 5
Cleaner Assembly - upright cleaner
UPC - 073502032183
View all Hoover FH40010B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1. Cleaner ASSEMBLY Carton contents 1.1 B C D A E A. Hard floor cleaner B. Upper handle C. Brush assembly D. Nozzle E. Hard Floor Cleaning Detergent Remove all parts from carton and identify each item shown. Make sure all parts are located before disposing of packing materials. NOTE: Phillips screwdriver needed for assembly. Attach handle 1.2 Rotate bottom handle support (A) up to the upright position until a snap is felt. 1.3 Align control rod (B) on upper handle (C) with slot in bottom handle support (D). Push upper handle (C) all the way down until you hear it snap in place. 1.2 A Install brushes and nozzle 1.4 To install brushes, place handle in upright 1.4 B position. Tilt cleaner back so that it rests on the floor. Align post (A) on brush block with hole (B) on bottom of cleaner. Turn brushes slightly until post fits easily into hole. 1.5 Press brush assembly firmly to snap into place. A 1.6 To install nozzle, make sure latches (C) are out. Align middle section (D) of nozzle with opening (E) on cleaner. Remove cardboard packing insert from squeegee area on underside of nozzle. 1.6 DE C 1.7 While holding nozzle in place, slide latches inward to lock in place. 1.3 C D B 1.5 1.7 5