Hoover FH40010B Manual - Page 8

The Tanks: Clean Water Solution Tank (upper tank) Turn cleaner off and disconnect from electrical outlet. The Clean Water Solution Tank holds detergent and water that is to be dispersed onto the surface being cleaned. How to Fill Place carpet cleaner handle in the upright, locked position. 2.8 To remove tank, squeeze release button and pull tank straight out. Carry tank to a sink. 2.9 Rotate tank cap counter-clockwise and lift up to remove cap (A). 2.10 Turn cap (B) upside down to serve as a measuring cup. For hard surface floors such as vinyl, linoleum, marble, laminate wood, polyurethane sealed wood or other wood floors that can normally be cleaned using water, use one cup (2 oz.) HOOVER® Hard Floor Detergent. Check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor. 2.11 Pour cleaning concentrate into tank (C). Fill tank to fill line (D) (1 quart) with warm water. 2.12 If rubber ring (E) on cap has become dislodged, reposition it with uneven side against ledge (F) as shown. 2.13 Replace cap. Rotate cap clockwise until it locks in place. Cap must be locked in place for proper performance and to prevent leaking. 2.14 Slide tank straight into position until latch snaps in place. 2.8 2.10 2.12 E 2.14 ! CAUTION ! DO NOT use cleaning concentrates that contain solvent based ingredients. 2.9 A 2.11 C B D 2.13 F 8