Hotpoint RVM5160MPSA Installation Instructions - Page 14
Adapting Blower For, Recirculation, Mount The Oven
View all Hotpoint RVM5160MPSA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installation Instructions A4. ADAPTING BLOWER FOR RECIRCULATION (continued) 5 Place the blower unit back into the opening. CAUTION Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: When mounting the oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift oven, tilt it forward and hook slots at back bottom edge onto two lower tabs of mounting plate. 6 Replace blower motor screws removed in Step 2. Slide cover plate into position on the back of the unit. Replace blower plate and screws removed in Step 1. Attach second cover plate on blower plate (including one screw). Cover Plate Blower Plate Screws Blower Plate Back of Oven Blower Motor Screws Cover Plate A5. MOUNT THE OVEN 2 Rotate front of oven up against cabinet bottom. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess Self-Aligning Screw Oven Top FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws. 14 31-7000091 Rev. 2