Hotpoint RVM5160MPSA Installation Instructions - Page 15

Installation Instructions A4. MOUNT THE OVEN (continued) 3 Attach the oven to the top cabinet by inserting 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw. Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. 4 Tighten the two screws to the top of the oven completely. (While tightening screws, hold the oven in place against the wall and the top cabinet.) A6. WHEN REPLACING THE CHARCOAL FILTER If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors. The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6 to 12 months, depending on hood usage). See your Owner's Manual for the filter kit number. To replace the charcoal filter: 1 Open the microwave door. 2 Remove 2 screws from the top of the grille. (You may need to open the cabinet doors to remove the screws. 3 Slide the grille to the left and forward to remove. Charcoal Filter 5 Install grease filters. See the Owner's Manual packed with the oven. 4 Slide the old filter down and out to remove it. 5 Remove plastic and other outer wrapping from the new filter and install the new filter. When properly installed, the wire mesh of the filter should be visible from the front. 6 Replace the grille and the 2 screws. 7 Close the door. 31-7000091 Rev. 2 Insert filter mesh-side up 15