Hunter 42177 Owner's Manual - Page 27
Span Setting, by causing your system to run SHORTER.
View all Hunter 42177 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
3 Operation Span Setting Your thermostat is set at the factory to cycle at 1°F (0.5°C) above and below the set temperature. (Span = 2) This setting has been designed to provide a comfortable room temperature under most all conditions. However, if you find your system cycling too fast or too slow, then the Span can be adjusted to modify the cycle time. 1. Press and hold BOTH for three seconds. The display will flash, and SPAN will be displayed on the LCD. 2. Press to raise the Span to 3. This setting INCREASES the cycle time by allowing your system to run LONGER. 3. Press to lower the Span to 1. This setting DECREASES the cycle time by causing your system to run SHORTER. The Span settings remain the same for both HEAT and COOL, and can be changed in any System Switch position. When batteries are installed in the thermostat, or the Reset key is pressed, the Span is reset back to setting 2. ©2010 Hunter Fan Company 27