Hunter 42177 Owner's Manual - Page 32

Problem, Solution, Heating or Cooling Does Not Go On or Off.

Get Hunter 42177 PDF manuals and user guides View all Hunter 42177 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Thermostat Assistance Troubleshooting 5 Problem: Heating or Cooling Does Not Go On or Off. Solution: 1. Check that the function switch is in the correct position ("HEAT" or "COOL"). 2. There may be as much as 4-minute delay before the system turns On - wait and check. (Compressor protection delay.) 3. Check your circuit breakers and switches to ensure there is power to the system. 4. Replace batteries. 5. Make sure your furnace blower door is closed properly. 6. If your system only uses 4-wires, be sure the jumper wire is installed between the Rc and Rh terminals. Problem: Thermostat permanently reads "HI", "LO", or "Er". Solution: 1. Press the reset button once with a small pin and hold for two seconds. Then reprogram. 32 2. Replace unit. 44043-01 • 02/19/2010

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
44043-01
•
02/19/2010
32
Problem:
Heating or Cooling Does Not Go On or Off.
Solution:
1. Check that the function switch is in the correct position (“HEAT” or “COOL”).
2. There may be as much as 4-minute delay before the system turns On - wait and
check. (Compressor protection delay.)
3. Check your circuit breakers and switches to ensure there is power to the system.
4. Replace batteries.
5. Make sure your furnace blower door is closed properly.
6. If your system only uses 4-wires, be sure the jumper wire is installed between
the Rc and Rh terminals.
Problem:
Thermostat permanently reads “HI”, “LO”, or “Er”.
Solution:
1. Press the reset button once with a small pin and hold for two seconds. Then
reprogram.
2. Replace unit.
5
°ermostat Assistance
Troubleshooting