Husqvarna 572 XP G Owner Manual - Page 15
To use the cutting technique
View all Husqvarna 572 XP G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2. Cut approximately ⅔ through the trunk and then stop. Turn the trunk and cut from the opposite side. 1. 2. To use the cutting technique WARNING: Use full throttle when you cut and decrease to idle speed after each cut. CAUTION: Engine damage can occur if the engine runs for too long at full throttle without load. 1. Put the trunk on a saw horse or runners. To cut a trunk that has support on one end WARNING: Make sure that the trunk does not break during cutting. Obey the instructions below. WARNING: Do not cut trunks in a pile. That increases the risk of kickback and can result in serious injury or death. 2. Remove the cut pieces from the cutting area. WARNING: Cut pieces in the cutting area increase the risk of kickback and that you can not keep your balance. To cut a trunk on the ground 1. Cut through the trunk on the pull stroke. Keep full throttle but be prepared for sudden accidents. 1. Cut on the push stroke approximately ⅓ through the trunk. 2. Cut through the trunk on the pull stroke until the two kerfs touch. 2. 1. To cut a trunk that has support on two ends WARNING: Make sure that the saw chain does not get caught in the trunk during cutting. Obey the instructions below. WARNING: Make sure that the saw chain does not touch the ground when you complete the kerf. 1. Cut on the pull stroke approximately ⅓ through the trunk. 140 - 007 - 04.06.2020 15