Husqvarna 572 XP G Owner Manual - Page 24
To replace a broken or worn starter
View all Husqvarna 572 XP G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
To do a check of the right hand guard • Make sure that the right hand guard is not damaged and that there are no defects, such as cracks. 2. Make sure that the muffler is correctly attached to the product. To do a check of the vibration damping system 1. Make sure that there are no cracks or deformation on the vibration damping units. 2. Make sure that the vibration damping units are correctly attached to the engine unit and handle unit. Refer to Product overview on page 2 for information about where the vibration damping system is on your product. To do a check of the start/stop switch 1. Start the engine. 2. Press the start/stop switch down to the STOP position. The engine must stop. 3. If your product has a special spark arrestor mesh, clean the spark arrestor mesh weekly. 4. Replace a damaged spark arrestor mesh. CAUTION: If the spark arrestor mesh is blocked the product becomes too hot and this causes damage to the cylinder and piston. To do a check of the muffler WARNING: Do not use a product that has a defective muffler or a muffler that is in bad condition. WARNING: Do not use a product if the spark arrestor mesh on the muffler is missing or defective. 1. Examine the muffler for damages and defects. Your product has the function that adjusts the carburetor automatically, which gives the best possible adjustment. lets the engine adapt to weather conditions, altitude, gasoline and the type of two-stroke oil. CAUTION: If does not work correctly, speak to your servicing dealer. The product adjusts correctly after some fuelings. To replace a broken or worn starter rope 1. Loosen the screws to the starter housing. 2. Remove the starter housing. 24 140 - 007 - 04.06.2020