Husqvarna L321AH Owner Manual - Page 17

2. Install the discharge chute. To empty the grass catcher CAUTION: Do not drag the bag when you empty the grass catcher to prevent wear. 1. Lift the grass catcher with the frame handle. 2. Remove grass clippings from the grass catcher from below the handle. 3. Empty grass clippings from the bag with the frame handle and the bag handle. To get a good result • Always use a sharp blade. A blunt blade gives an irregular result and the cut surface of the grass becomes yellow. A sharp blade also uses less energy than a blunt blade. • Do not cut more than ⅓ of the length of the grass. Cut first with the cutting height set high. Examine the result and lower the cutting height to an applicable level. If the grass is very long, drive slowly and cut 2 times if necessary. • Cut in different directions each time to prevent stripes in the lawn. Introduction Maintenance Maintenance schedule WARNING: Before you do maintenance, you must read and understand the safety chapter. CAUTION: Make sure that the air filter is up and not against the ground when you tilt the product. Risk of engine damage. For all servicing and repair work on the product, special training is necessary. We guarantee the availability of professional repairs and servicing. If your dealer is not a service agent, speak to them for information about the nearest service agent. The maintenance intervals are calculated from daily use of the product. The intervals change if the product is not used daily. For maintenance identified with * refer to instructions in Safety devices on the product on page 5. Maintenance Do a general inspection Examine the oil level Clean the product Daily X X X Weekly Monthly 1240 - 001 - 08.07.2019 11