Husqvarna ST 427 Owner Manual - Page 10
To install the discharge chute, To install the discharge chute lever, and the release cable
View all Husqvarna ST 427 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
A B A B C C 3. Put the bolt (B) through the hole (C). 4. Attach the knob (A) to the bolt and tighten the knob. 5. Attach more carriage bolts (B) and handle knobs (A) to attach the upper handle to the lower handle. To install the discharge chute 1. Put the deflector assembly for the discharge chute on the top of the discharge chute. The discharge opening must point to the front of the product. 2. Put the rotator head (A) on the discharge chute bracket (J). 3. Align the pins below the rotator head with the holes in the discharge chute bracket. 4. Put the rotator head on the pin (E), and the threaded stud (G) on the bracket (F). J I H G D K E F 5. Attach a locknut (B) on the threaded stud and tighten. 6. Attach the square retainer (I) with a locknut (H). 7. Put the cables through the hook cable slot. • For ST 424, ST 427, ST 430 use hook cable slot (C). • For ST 424T, ST 427T, ST 430T use hook cable slot (K). To install the discharge chute lever and the release cable 1. Push the knob (D) down on the discharge chute lever. Use a rubber mallet if it is necessary. 2. Attach the release cable to the discharge chute lever at connection (A). D C E B A F 3. Put the release cable in the groove (B) on the discharge chute lever. 4. Install the cable barrel fitting (F) to the release lever (E). 5. Install the release lever (E) to the discharge chute lever and attach it with the roll pin (C). 6. Adjust the release cable. See To adjust the release cable of the discharge chute on page 24. 10 876 - 011 - 11.05.2020