Husqvarna ST 427 Owner Manual - Page 27
Problem, Possible cause, Solution
View all Husqvarna ST 427 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Problem Possible cause Solution Decreased power The spark plug cable is not connected. Connect the cable to the spark plug. The product throws too much snow. Decrease the speed and the width of the swath. The fuel tank cap is covered with ice or snow. Remove the ice and the snow on and around the fuel tank cap. The muffler is dirty or clogged. Clean or replace the muffler. Improper cable length. Adjust the cable. The muffler is blocked. Make sure that the engine is cool. Clear the blockage. The air intake of the carburetor is blocked. Make sure that the engine is cool. Clear the blockage. The fuel injector does not trigger. Contact an authorized service center. The engine idles or runs roughly The fuel line is blocked. There is water in the fuel or the fuel is too old. Clean the fuel line. Empty the fuel tank and carburetor. Fill the fuel tank with fresh, clean gasoline. The carburetor needs to be replaced. Contact an authorized service center. The fuel injector does not trigger. Contact an authorized service center. Excessive vibration / Handle movement Some parts are loose. The augers are damaged. Tighten all fasteners. Replace the damaged parts. If vibration remains, contact an authorized service center. The handles are not positioned correctly. Make sure that the handles are locked into position. The adjustment lever nuts are loose. Tighten the nuts until the handle feels safe. The starter rope handle The starter rope handle is frozen. is hard to pull Slowly pull out as much rope out of the starter as possible and release the starter rope handle. If the engine does not start, repeat the procedure or use the electrical starter. The starter rope is interfering with components. The starter rope should not touch any cables or hoses. 876 - 011 - 11.05.2020 27