IBM 1735R16 User Guide - Page 57
Firmware Management, Enable Debug Messages, Set/Change Password, To activate security
View all IBM 1735R16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
50 RCM Installer and User Guide Firmware Management This menu option contains the FLASH Download command. The FLASH Download selection allows you to keep your RCM firmware current with upgrades available from IBM. For more information see Appendix A: FLASH Upgrades. Enable Debug Messages This menu option allows you to configure the RCM to display messages regarding the status of the RCM. Once you select the level of detail to receive, the RCM will begin to display information on your terminal screen. When you are finished viewing, press any key to exit this mode. Set/Change Password The RCM can be set to a secure mode where the Terminal menu cannot be accessed without first entering a password. To activate security: 1. Select the Set/Change Password menu option. You will be prompted with the option to continue. Enter a Y. 2. Type a password for this RCM and press Enter. This password must be a minimum of 5 characters and can be up to a maximum of 12 characters (10 are visible). The password must consist of a combination of alpha and numeric characters. 3. You will be prompted to re-type the password. Once you complete this step, security will be active and you will not be able to access RCM terminal operations without the password. To change the password: 1. Select the Set/Change Password menu option. 2. You will be prompted to type the old password and a new one. 3. Re-enter the new password to verify. ATTENTION: This password places your RCM terminal in a secure mode. This password should be guarded like any network password and care should be taken to avoid forgetting or misplacing it. There are no means for recovering a lost password. Exit This menu selection will return you to the ready prompt.