IBM 2498B24 User Guide - Page 52
Removing SFP modules, implement such as a screwdriver to press the release trigger beneath the port. - express system storage
UPC - 883436031462
View all IBM 2498B24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Removing SFP modules To remove an SFP: 1. Press and hold the cable release B , as shown in section 1 of Figure 10 2. Remove the cable from the SFP, as shown in section 2. 3. Pull the bail (wire handle) D in section 3 to release the SFP. 4. Grasping it by the bail, gently but firmly pull the SFP ( C in section 4) out of the port. Attention: If the SFP you are removing does not have a bail, use a small implement such as a screwdriver to press the release trigger beneath the port. Non-bailed SFPs can be damaged by the removal process and are not recommended. Refer to the interoperability matrix at the following web site: www.ibm.com/servers/storage/support/san for a list of supported SFPs and devices. 5. Repeat this procedure for the remaining ports, as required. B 1 E A IOIOI ! D scale: 1/8" = 1" C 3 mAM oTauxTniEmtinNugmTtosIcObreeNw5lm:enmgtohrfo1r3r/a6c4k in. C B24_0005 2 Figure 10. Removing an SFP Item A B 28 SAN24B-4 Express Installation, Service, and User Guide 4 Description Switch chassis Cable release