IBM 2498B24 User Guide - Page 59

System specifications Table 12 lists the system specifications for the switch. Table 12. General specifications Specification Autoconfiguring port types System architecture System processor SDRAM Compact flash ANSI Fibre Channel protocol Modes of operation Fabric initialization Ethernet port Terminal port ASIC Port Status LEDs System Power LED System Status LED Ethernet LEDs Power supply Fans FC-IP (IP over Fibre Channel) Aggregate switch I/O bandwidt Port-to-port latency Descriptions F_Port, FL_Port, M_Port, N_Port, and E_Port Nonblocking shared-memory switch IBM PowerPC 440EPx, 667 MHz 512 MB DDR2 SDRAM onboard memory operating at 133 MHz 1 GB FC-PH (Fibre Channel Physical and Signalling Interface standard) Fibre Channel Class 2, Class 3, Class F Complies with FC-SW-2 6.6 One 10/100BaseT Ethernet port; accessed through RJ45 connector One UART interface for terminal, accessed through RJ-45 connector Goldeneye-2 ASIC for Fibre Channel Switching 24 LEDs (green/amber) to indicate status for each port One LED (green) to indicate system power One LED (green/amber) to indicate system status Two Ethernet LEDs to indicate speed and link status One fixed power supply (not a FRU) Three fixed fans operating at dual speeds (not a FRU). Complies with FC-IP 2.3 of FCA profile 384 Gbps if all 24 ports running at 8 Gbps, full duplex Less than 700 nanoseconds with no contention (destination port is free) Memory specifications The switch memory specifications are shown in Table 13. Table 13. Memory specifications Memory type Main memory (SDRAM) Compact flash Installed memory 512 MB 1 GB Appendix. Product specifications 35