IBM 4368E3U User Manual - Page 63
Installing, hot-swap, power, supply
View all IBM 4368E3U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
10. Install the side cover (see "Reinstalling the side cover" on page 54). 11. Lock the side cover. 12. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server. Installing a hot-swap power supply The following notes describe the type of power supply that the server supports and other information that you must consider when you install a power supply: v The type and number of power supplies vary by server model. The server comes with at least one power supply. v Some servers come with a hot-swap power supply that supports redundant mode. The redundant mode requires two operational hot-swap power supplies in the server. This procedure applies only to server models that have hot-swap power supplies. If the server contains a non-hot-swap power supply that requires replacement, the power supply must be replaced by a service technician. When you remove or install a hot-swap power supply, observe the following precautions. Statement 8: CAUTION: Never remove the cover on a power supply or any part that has the following label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician. Chapter 2. Installing optional devices 49