IBM 6500-V15 Maintenance Manual - Page 169

Operator Panel Message SPX NOT NEEDED OPTIONS ENABLED TESTING HARDWARE PLEASE WAIT TOP OF FORM SET WAITING FOR ETHERNET ADAPTER WAITING FOR PROGRAM DOWNLOAD Display Messages Table 3. Message List Explanation Corrective Action The user has attempted to use the SPX to turn on printer options that are already enabled. In such a case the SPX does not copy the security key serial number into its memory and does not deplete itself. 1. Remove the SPX from the RJ-12 Debug Port. 2. Cycle printer power. Status message when printer runs self-tests and initialization routines. No action required, but if the printer "hangs" at this message, refer to "Printer does not complete IML," page 185. Non-error status message. No action required. Status message that appears when printer is first powered on if the internal Network Interface Card is installed. An Ethernet adapter must be detected early in the power up sequence so the printer can tell the adapter it has been detected and continue with its own power up sequence. Compared to the printer, the Ethernet adapter takes a long time to complete its internal diagnostic tests, so the boot code allows the adapter to power up in parallel with the printer to reduce its effect on overall boot time No action required, but if the printer "hangs" with this message displayed, refer to the ethernet reset procedures in the Ethernet User's Manual. Emulation download mode has been activated, but program download has not yet begun. No action required. 169