IBM 6500-V15 Maintenance Manual - Page 248
Loading Through the Network Interface Card (NIC
![]() |
View all IBM 6500-V15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
Message RESTORING BOOT CODE SECURITY CODE VIOLATION SENDING PROGRAM TO EC PROCESSOR Table 6. Flash Memory Message Guide Explanation Normal download initialization message. None Required Action The software running or being downloaded does not match the security key code. The printer is loading the engine controller program into the engine controller. Install the correct key or program. (Key and program must match.) None Loading Through the Network Interface Card (NIC) IMPORTANT To load software through the NIC you need the IP Address of the printer and the flash memory must be operational and contain basic printer code (it cannot be a blank replacement SIMM). 1. Make a configuration printout of all saved configurations. (Refer to the User's Manual.) NOTE: If you have a problem loading code, call your Level 2 Support Group for assistance. 2. Set the printer power switch to O (Off). 3. Plug an ethernet cross-over cable (IBM P/N 09J7206, or equivalent from a local computer/electronics shop) into the NIC and your laptop. 4. Press and hold the START + EJECT keys. Without releasing the keys, power the printer on. When you see "B30 STATUS: INITIALIZING" on the on the LCD, release the keys. 5. Wait until you see "WAITING FOR DOWNLOAD" on the LCD before proceeding. This can take up to 30 seconds to appear, depending on the emulations and interfaces installed in the printer. 6. Open the command prompt on the laptop. At the C:\> prompt type the following: MD download CD\ CD download 248
![](/manual_guide/products/ibm-6500v10-maintenance-manual-719aa36/248.png)