IBM 6500-V15 Maintenance Manual - Page 57
Table 3. Message List, Corrective Action
View all IBM 6500-V15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Operator Panel Message 032 FORMS JAMMED TIMEOUT CLEAR AND RELOAD FORMS Display Messages Table 3. Message List Explanation Corrective Action On a coax interface, a timeout message is sent to the host if paper motion has not occurred for 10 minutes after STOP was pressed to clear a paper jam fault. 1. Clear the paper jam. Press STOP. 2. Press FORM FEED several times and check that forms feed without erratic motion, noise, or pin-hole damage. If forms do not feed, go to Paper feeds poorly, page 202. If forms feed, go to step 3. 3. Press VIEW once and check that forms move up. Make sure the forms thickness lever is not set too tightly. 4. Press VIEW again and check that the forms thickness lever rotates and the paper moves down. If the forms thickness lever does not rotate and/or the paper does not move down, refer to Reverse paper feed: platen does not open, page 205. 5. Check the paper tension between the tractors. Adjust the right tractor so that it does not pull paper too tightly or leave it too loose. The right tractor should hold the paper under "slight" tension. 6. Inspect the ribbon mask for bends or deformation that block the paper path or prevent paper from exiting the pedestal top cover. Replace a damaged hammer bank cover assembly. 7. Check and adjust the platen open belt. Replace the belt if it is damaged. 8. Inspect the tractors and tractor door springs for damage, excessive wear, and equal door closing tension. If either tractor is worn, damaged, or exhibits uneven door closing tension, replace both tractor assemblies. 9. Adjust the paper feed belt. Replace the belt if it is damaged. 10. Check and adjust the platen gap. 57