IBM 6500-V1P Maintenance Manual - Page 122
Shutl Driver Failed, See Users Manual
View all IBM 6500-V1P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Operator Panel Message 143 SHUTL DRIVER FAILED * SEE USERS MANUAL Display Messages Table 3. Message List Explanation Corrective Action Shuttle driver failed. The shuttle driver circuit on the controller board is drawing too much current. 1. Power off and unplug the printer. Remove the paper guide assembly or top cover to gain access to the card cage. Make sure the shuttle data and power cables are undamaged and have good connections at the shuttle and the controller board. 2. Check the shuttle for electrical shorts (page 252). 3. Plug in the printer and power it on. If the message appears, the controller board or microcode is suspect. Do the following: 4. Save the printer configuration values. (Refer to the User's Manual.) 5. Clear NVRAM (page 237). 6. Download and install the latest code from IBM First (page 231). 7. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 8. Download and install the latest code from IBM First (page 231). 9. Power on the printer in download mode and load flash memory (page 238). 10. If you encounter the failure after replacing the controller board, reinstall the original controller board and contact your DDS and Second Level Support. 11. Power on the printer. If the message appears, replace the shuttle frame assembly. 122