IBM 6500-V1P Maintenance Manual - Page 65

Display Messages Operator Panel Message 058 SHUTL JAM SEE USERS MANUAL (continued) 059 CANCEL PRINT ACTIVE Table 3. Message List Explanation Corrective Action Non-error status message. 8. Run a print test. If the problem reappears, the controller board or microcode is suspect. Do the following: 9. Save the printer configuration values. (Refer to the User's Manual.) 10. Clear NVRAM (page 237). 11. Download and install the latest code from IBM First (page 231). 12. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 13. Download and install the latest code from IBM First (page 231). 14. Power on the printer in download mode and load flash memory (page 238). 15. If you encounter the failure after replacing the controller board, reinstall the original controller board and contact your DDS and Second Level Support. 16. Run a print test. If the message appears, remove the shuttle frame assembly and place it on a hard, flat surface. Rotate the flywheel by hand and check for any binding. The flywheel should spin more than one turn. If it fails this test, replace the shuttle frame assembly. 17. Run a print test. If the message appears, do the power supply operational check (page 258). If the power supply fails the check, replace it. If it passes the check, contact your DDS and Second Level Support. No action required. 65