IBM 6500-V1P Maintenance Manual - Page 47

Operator Panel Message 006 HOST SYSTEM REQUEST ATTENTION 007 FM HEADER ERROR 008 HOLD PRINT TIMEOUT PRESS START 009 INVALID KEY PRESS 010 PARAMETER ERROR 011 SCS COMMAND ERROR Display Messages Table 3. Message List Explanation Corrective Action Host attention message: the host computer or printer controller requires attention. Not a printer problem. Applications software has violated Not a printer problem. Have the system administrator correct header format parameters. applications data or configuration. Status message: the printer was offline more than 10 minutes and the "Intervention Required" parameter is set to "Send to Host." Press START to put the printer in the READY state. Attention message informing the operator that the wrong key was pressed. No action required. The printer received an illegal parameter value in the command code. 1. Press STOP to clear the fault. Press START to go to the READY state. 2. Run the print job that generated the error message. If the message appears, check the host data for invalid characters. 3. Ask the system operator to verify that the printer's Device ID is set to the correct emulation with respect to the host configuration. 4. Run the print job that generated the error message. If the message appears, go to Communications Failures, page 211. The printer received an undefined control character (hex 40) through the coax/twinax interface. 1. The printer clears the error. 2. Run the print job that generated the error message. If the message appears, verify that there are no invalid control codes in the host data. 3. Ask the system operator to verify that the printer's Device ID is set to the correct emulation with respect to the host configuration. 4. Run the print job that generated the error message. If the message appears, go to Communications Failures, page 211. 47