IBM 6500-V1P Maintenance Manual - Page 208
If you encounter the failure after replacing the controller board, reinstall the original controller
View all IBM 6500-V1P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Symptom Printer resets to factory defaults General Symptom List Table 5. General Symptom List Corrective Action 1. Check the printer configuration for the proper values of CPI, LPI, print quality, forms length, and width. 2. Refer to the reset command description in the User's Manual. 3. If the problem reappears, the controller board or microcode is suspect. Do the following: 4. Save the printer configuration values. (Refer to the User's Manual.) 5. Clear NVRAM (page 237). 6. Download and install the latest code from IBM First (page 231). 7. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 8. Download and install the latest code from IBM First (page 231). 9. Power on the printer in download mode and load flash memory (page 238). 10. If you encounter the failure after replacing the controller board, reinstall the original controller board and contact your DDS and Second Level Support. 208