IBM 6500-V20 Maintenance Manual - Page 115

Operator Panel Message 135 INVALID STATE * SEE USERS MANUAL Display Messages Table 3. Message List Explanation Corrective Action Platen invalid state. Firmware error on the controller board. 1. Cycle power. Run the print job again. If the message appears, download the emulation software again. 2. Power on the printer. If the problem reappears, the controller board or microcode is suspect. Do the following: 3. Save the printer configuration values. (Refer to the User's Manual.) 4. Clear NVRAM (page 237). 5. Download and install the latest code from IBM First (page 231). 6. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 7. Download and install the latest code from IBM First (page 231). 8. Power on the printer in download mode, and load flash memory (page 238). 9. If you encounter the failure after replacing the controller board, reinstall the original controller board and contact your DDS and Second Level Support. 115