IBM 6500-V20 Maintenance Manual - Page 380

Adjusting The End Of Forms Distance 17. Press ENTER. The number of dots will move up to the top line of the display. 18. Using the SCROLL↑ or SCROLL↓ key, adjust the XX DOTS value up or down by the number of dots you counted in step 12. (If the comb pattern stopped short of the perforation, increase the number of dots. If the comb pattern printed beyond the perforation, decrease the number of dots.) 19. Press ENTER to select the new number of dots as the active value. (The asterisk that appears tells you that it is now the active value.) 20. Press STOP to put the printer into NOT READY mode. 21. Run the END OF FORMS ADJUST and the END OF FORMS ADJUSTMENT VALUE tests until the comb pattern prints at an acceptable distance from the page perforation. (Return to step 7.) 22. When the End of Forms Adjustment is acceptable, reload the paper, feed it past any remaining unused holes that you tore in it, and set the top of form. 23. Press RETURN + ENTER to lock the ENTER key. 24. Press START to put the printer into READY mode. 380