IBM 6500-V20 Maintenance Manual - Page 83
Table Mismatch error., CONTROL 15V CHECK, SEE USERS MANUAL
View all IBM 6500-V20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Operator Panel Message 086 CONTROL 15V CHECK SEE USERS MANUAL Display Messages Table 3. Message List Explanation Corrective Action Controller voltage failure. 1. Make a configuration printout and note the customer's code load (if possible). 2. Power down and unplug the printer. 3. Replace the hammer bank logic cable. There may be damage you cannot see. 4. Power on the printer. If the problem persists, do the cable shorts test (page 254) on the hammer bank (HB) power cable. Replace the cable if necessary. NOTE: When reconnecting the HB power cable, make sure pin 1 on the cable connector matches pin 1 on the PCBA connector. Plugging the HB power cable in backwards can result in a "Table Mismatch" error. 5. Make sure the cables are properly tie-wrapped away from the reciprocating shuttle. Spin the shuttle motor by hand to check that the cables are clear of the shuttle as it moves. 6. You can easily verify that when the shuttle cover is installed, the hammer bank logic cable is clear of the shuttle by removing the paper scale on the shuttle cover, as follows: a. Remove the paper scale BEFORE installing the cover to reduce the chance of losing a screw in the machine. Mark a location reference line with a pencil across the paper scale and cover. Remove the three screws holding the paper scale. b. Install the shuttle cover and fasten it in place. Look in past the shuttle cover to verify the position of the hammer bank logic cable. If it is near the shuttle, remove the cover and push or tie the cable back. c. When the cable position is OK, install the paper scale, being careful not to drop any of the three screws. Erase the pencil line. 83