IBM 8649 Hardware Maintenance Manual - Page 95
Before, begin
UPC - 000435133427
View all IBM 8649 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Rear fans Before you begin: v Read "Safety information" on page 129 v Review the information in "System reliability considerations" on page 33 To remove a rear fan, complete the following steps: 1. Turn off the server, if it is on. 2. Unplug the server. 3. Remove the side cover. See "Removing the side cover" on page 36 4. Remove the frame-support bracket. See "Removing and installing the support bracket" on page 38 5. Remove the airflow guide and air baffle. 6. Remove the fan cable from the system board. 7. Use side cutters to sever the four rubber extensions on the outside of the server. 8. Gently pry the fan away from the server and lift it up and out. Rubber extensions To install the new rear fan assembly, complete the following steps: 1. Place the fan in position at the rear of the server. 2. Guide the rubber extensions through the apertures. 3. Use needle-nosed pliers to pull the extensions through the apertures. 4. Reconnect cables. Chapter 5. Field replaceable units 85