IBM 8649 Hardware Maintenance Manual - Page 99
Removing, system, board
UPC - 000435133427
View all IBM 8649 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
14. Replace the side cover (see "Replacing the side cover" on page 67). 15. Reconnect the external cables and power cords; then, turn on the attached devices and the server. Removing the system board Before you begin: v Read "Safety information" on page 129 v Review the information in "System reliability considerations" on page 33 Notes: 1. When replacing the system board, you must either update the system with the latest firmware or restore the pre-existing firmware that the customer provides on a diskette or CD image. 2. It is recommended that the server be placed on its left side before performing this service procedure. Rotate the feet in toward the server so they do not detach due to the weight of the server. To remove the system board, complete the following steps: 1. Turn off the server, if it is on. 2. Unplug the server and disconnect the power cord; then, disconnect all external cables. 3. Remove the side cover. See "Removing the side cover" on page 36 4. Remove the front bezel. See "Removing the bezel" on page 37 5. Remove the frame-support bracket. See "Removing and installing the support bracket" on page 38 6. Disconnect the cables. 7. Remove both adapter-retaining brackets and the adapters (see "Installing an adapter" on page 40). 8. Remove the air flow guide and the air baffles from over the microprocessor. 9. Remove memory modules. See "Installing memory modules" on page 55 10. Remove the mini-PCI video adapter. See "Mini-PCI video adapter" on page 86 11. Remove the microprocessor. See "Microprocessor and heat sink" on page 77 Chapter 5. Field replaceable units 89