IBM HS40 Setup Guide - Page 20

Run PXE only on selected Planar NIC, Yes, exit the Setup Utility

Get IBM HS40 - BladeCenter - 8839 PDF manuals and user guides
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

e. If your blade server does not support PXE/BOOTP booting or installation and SOL on Planar Ethernet 1 at the same time, select Start Options; then, set the following values: v Planar Ethernet PXE/DHCP to Planar Ethernet 2 v Run PXE only on selected Planar NIC to Enabled f. Press Esc to exit the Start Options section of the Configuration/Setup Utility program. g. Select Save Settings; then, press Enter. h. Press Enter to confirm. i. Select Exit Setup; then, press Enter. j. Make sure that Yes, exit the Setup Utility is selected; then, press Enter. 14 BladeCenter: Serial over LAN Setup Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
e.
If your blade server does not support PXE/BOOTP booting or installation
and SOL on Planar Ethernet 1 at the same time, select
Start Options
; then,
set the following values:
v
Planar Ethernet PXE/DHCP
to
Planar Ethernet 2
v
Run PXE only on selected Planar NIC
to
Enabled
f.
Press Esc to exit the
Start Options
section of the Configuration/Setup Utility
program.
g.
Select
Save Settings
; then, press Enter.
h.
Press Enter to confirm.
i.
Select
Exit Setup
; then, press Enter.
j.
Make sure that
Yes, exit the Setup Utility
is selected; then, press Enter.
14
BladeCenter: Serial over LAN Setup Guide