Icom IC-M605 Instruction Manual - Page 110
Microphone installation, Installation
![]() |
View all Icom IC-M605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
12 CONNECTIONS AND MAINTENANCE ■■Microphone installation Connect the optional HM-195*1 or HM-229 to the transceiver using the supplied OPC-2384 conversion cable*2 and the OPC-1540 connection cable that comes with the microphone. *1 Not usable for the IC-M605EURO. *2May not be supplied, depending on the transceiver version. LLT o operate from even longer distances, connect the optional 6 meter long OPC-1541 microphone extension cable between the OPC-2384 and the OPC-1540. Up to two OPC-1541 can be added. You can also install the cable connector as a built-in plug on a cabinet or wall. NOTE: The firmware of HM-195/HM-229 may be update when you connect them to the transceiver. DDInstallation 1. C onnect the OPC-2384 and OPC-1540. 2. Connect the other side of the OPC-2384 to the command microphone connector, and tighten the nut. 3. To use the cable connector as a wall socket, install it as shown below. 4. Using the mounting base as a template, carefully mark the holes where the cable and 3 screws will be fastened. 5. Drill holes at these marks. 6. Install the mounting base using the supplied screws, as shown below. Mounting base Nut Gasket Screw holes (approximately 2 (d) mm, Cap 1/16 inch) 100
![](/manual_guide/products/icom-icm605-instruction-manual-e7bd8df/110.png)