Insignia NS-F27TV User Manual (English) - Page 11

Insignia NS-F27TV Television 5 Press or to enter the Auto Program sub menu. 6 Press or to select ANTENNA. Checking DTV signal strength You can check the strength of your DTV signal and determine whether you need to adjust your antenna or digital cable input. The stronger the signal strength, the less likely you are to experience picture degradation. To check DTV signal strength: 1 Go to the Preset menu. 7 Press or to select AIR or CABLE. In AIR mode, the television receives antenna signals. In CABLE mode the television receives cable television programs. Select: • AIR-If using a VHF/UHF antenna. • CABLE-If using cable television. If you have any questions about these settings, contact your dealer. 8 Press to select START. 9 Press or to start Auto Program. The television begins to search and memorize all available programs. It may take a few minutes to finish searching. Note The television first memorizes analog programs. After all available analog programs have been memorized, it begins to memorize DTV programs. During analog program memorizing, you can press MENU to stop the process. The television then starts memorizing DTV programs. If you want to stop DTV program memorizing, press MENU again. Skipping unwanted channels After saving channels into memory, you can skip unwanted channels so that only the channels you want to watch are selected with the CH+/buttons. To skip unwanted channels: 1 Go to the Preset menu. 2 Press or to select CH SETUP. 3 Press or to enter the CH SETUP menu. The bottom line on the CH SETUP menu shows the signal strength for the current DTV channel. Selecting channels You can use one of three methods to select a channel: • Use the number pad. • Use the CH+ and CH- buttons. • Use the previous channel button. Using the number pad To go to a specific channel number: • Press the number buttons (0-9) and the dash (-) button, then wait for the television to change channels, or press ENTER to go immediately to that channel. For example, if you want to select channel 8-3, press 8-3 on the remote control. (Make sure that you press the buttons within three seconds of each other, or the channel won't be entered correctly.) 2 Press or to select CH SETUP. 3 Press or to enter the CH SETUP menu. 4 Press or to select CH NO. 5 Press or to select a channel number. 6 Press to select SKIP. 7 Press or to select ON. The channel will be skipped when you browse through channels using the CH+/buttons. Tip To restore a skipped channel, use the number buttons to select the skipped channel, then repeat the previous steps and set SKIP to OFF. Note In some situations, virtual channel numbers do not correspond to physical frequencies. Using the CH+ and CH- buttons To browse through the channels: • Press: • CH+ to browse up the channels. • CH- to browse down the channels. Using the previous channel button To switch between two channels: • Press the previous channel button to switch between the current channel and the previous channel. Information about USA channel numbering • The ATSC PSIP channel uses a two part channel number which includes: • a major channel number www.insignia-products.com 9