Insignia NS-L32X-10A User Manual (English) - Page 12
Aiming the remote control, Using the remote control holder, Programming your remote control - wall mount
View all Insignia NS-L32X-10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
2 Insert two AA batteries into the battery compartment. Make sure that you match the + and - symbols on the batteries with the + and - symbols in the battery compartment. Using the remote control holder Your TV comes with a remote control holder you can put the remote control in when you are not using it. You can put the holder on a table or mount it on a wall. Screws Tape 3 Replace the battery cover. Cautions • Batteries should not be exposed to excessive heat, such as sunshine, heat registers, or fire. • Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a cloth. If chemicals touch your skin, wash immediately. • Make sure that batteries are disposed of correctly. Do not burn or incinerate. Notes Do not mix batteries of different types. Do not mix old and new batteries. Remove batteries when the charge is depleted. If the remote control is not going to be used for an extended period of time, remove the batteries. Aiming the remote control To aim the remote control: • Point the remote control towards the remote sensor on the front of your TV. Notes Do not expose the remote control to shock or liquids. Do not use the remote control in an area with high humidity. Do not place the remote control in direct sunlight. Do not place objects, such as furniture, between the remote control and the remote sensor. The remote control may not work if direct sunlight or bright light shines on the remote sensor. Either move your TV or change the angle at which you use the remote control. Tips • Different types of walls may require different types of screws. If you want to wall mount the remote control holder, make sure that you use the correct screws for the type of wall. (Screws are not provided.) • The remote control holder is shipped with separate adhesive tape for wall mounting. This tape may not work with all types of walls. Make sure that you use the correct tape for the type of wall. Programming your remote control To program your remote to control home theater devices, follow these steps. Before proceeding, find the codes for the devices you want to program in "Manufacturers' codes" on page 37 and write them down or highlight them. To program your remote control: 1 Turn on the device (for example, a DVD player) and, if needed, load media such as a DVD. 2 Press the device key on the remote for the device that you want to program (TV, DVD, STB, or AUX). 3 Press and hold SET until the red LED blinks twice, then release. 4 Enter the first five-digit code for the device and brand that you wish to program. The LED blinks once as each digit is entered. If the code is valid, the LED blinks twice. Note If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again. 5 Aim the remote at the device and press (power). The device should turn off. If it does not, repeat Steps 3 through 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see "Searching for your code" below. 6 Repeat Steps 1 to 5 for the other devices you want to control. For future reference, write down each working device code. 8 www.insigniaproducts.com