Insignia NS-R5100 User Manual (English) - Page 16
Adjusting each channel level with test tone, Adjusting the current channel level, Memorizing - home theater receiver
View all Insignia NS-R5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Insignia NS-R5100 AV Digital Home Theater Receiver Adjusting each channel level with test tone The volume level of each channel can be adjusted easily with the test tone function. Note When the SPEAKER button is set to off, the test tone function does not work. To adjust each channel level: 1 Press the TEST button. The test tone mode is displayed and is heard from each channel's speaker for two seconds as follows: • FL-Front Left • C-Center • FR-Front Right • SR-Surround Right • SL-Surround Left • SW-Subwoofer Note When the speaker setting is "N (None or No)", the test tone of the corresponding channel is not available. 2 At each channel, press the select or buttons to adjust the level as desired until the sound level of each speaker sounds equally loud. 3 Press TEST to cancel the test tone function. Adjusting the current channel level After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes. You can adjust the current channel levels as desired. These adjusted levels are memorized into user's memory (CAL), not into preset memory (REF 1 and REF 2). To adjust the current channel level: 1 Press the CHANNEL LEVEL button. 2 Press the select or buttons to select the channel. The corresponding channel is selected as follows: • REF 1, 2 (or CAL) • FL •C • FR • SR • SL • SW • DTS or DD-Only when the digital signals from Dolby Digital or DTS program sources are input, these levels can be displayed. Note • • • Depending on the speaker settings ("N (None or No)") and surround mode, some channels cannot be selected. When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected. The LFE level (DD and DTS) is applied after exiting the menu. 3 Press the select or button to adjust the level of the channel. The LFE level can be adjusted within the range of -10~0 dB and other channel levels within the range of -15 ~ +15 dB. In general, we recommend the LFE level to be adjusted to 0 dB.(However, the recommended LFE level for some early DTS software is -10 dB.) If the recommended levels seem too high, lower the setting as necessary. 4 Repeat this procedure to adjust each channel level. Memorizing the adjusted channel levels You can memorize the adjusted channel levels into preset memory (REF 1 or REF 2) and recall the memorized levels whenever you want. To memorize the adjusted channel levels: 1 After completing the steps under "Adjusting the current channel level" on page 14, press the MEMORY/ENTER button. OR OR The memory mode (CAL) is displayed for several seconds. Wen the memory mode or channel level disappears, you can press this button again. The 1 of the REF 1 indicator flickers for several seconds. 2 Press the select or buttons to select REF 1 or REF 2. If the preset memory disappears, repeat step 1 above. 3 Press the MEMORY/ENTER button to confirm your selection. The adjusted channel levels have now been memorized into the selected memory. 14 www.insignia-products.com