Intel D845GVFN Product Specification - Page 54
Hard Drive Activity LED Connector, 8.3.2.2, Reset Switch Connector, 8.3.2.3, Power/Sleep
View all Intel D845GVFN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Intel Desktop Board D845GVFN Technical Product Specification 2.8.3.2.1 Hard Drive Activity LED Connector Pins 1 and 3 can be connected to an LED to provide a visual indicator that data is being read from or written to a hard drive. For the LED to function properly, an IDE drive must be connected to the onboard IDE interface. 2.8.3.2.2 Reset Switch Connector Pins 5 and 7 can be connected to a momentary SPST type switch that is normally open. When the switch is closed, the desktop board resets and runs the POST. 2.8.3.2.3 Power/Sleep LED Connector Pins 2 and 4 can be connected to a one- or two-color LED. Table 33 shows the possible states for a one-color LED. Table 34 shows the possible states for a two-color LED. Table 33. States for a One-Color Power LED LED State Off Steady Green Description Power off/sleeping Running Table 34. States for a Two-Color Power LED LED State Off Steady Green Steady Yellow Description Power off Running Sleeping NOTE The colors listed in Table 33 and Table 34 are suggested colors only. Actual LED colors are product- or customer-specific. 2.8.3.2.4 Power Switch Connector Pins 6 and 8 can be connected to a front panel momentary-contact power switch. The switch must pull the SW_ON# pin to ground for at least 50 ms to signal the power supply to switch on or off. (The time requirement is due to internal debounce circuitry on the Desktop Board D845GVFN.) At least two seconds must pass before the power supply will recognize another on/off signal. 54