Intel D915GMH Product Specification - Page 70
Hard Drive Activity LED Connector [Yellow]
View all Intel D915GMH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Intel Desktop Board D915GMH Technical Product Specification 2.8.2.4.1 Hard Drive Activity LED Connector [Yellow] Pins 1 and 3 [Yellow] can be connected to an LED to provide a visual indicator that data is being read from or written to a hard drive. Proper LED function requires one of the following: • A Serial ATA hard drive connected to an onboard Serial ATA connector • An IDE hard drive connected to an onboard IDE connector 2.8.2.4.2 Reset Switch Connector [Purple] Pins 5 and 7 [Purple] can be connected to a momentary single pole, single throw (SPST) type switch that is normally open. When the switch is closed, the board resets and runs the POST. 2.8.2.4.3 Power/Sleep LED Connector [Green] Pins 2 and 4 [Green] can be connected to a one- or two-color LED. Table 32 shows the possible states for a one-color LED. Table 33 shows the possible states for a two-color LED. Table 32. States for a One-Color Power LED LED State Off Steady Green Description Power off/sleeping Running Table 33. States for a Two-Color Power LED LED State Off Steady Green Steady Yellow Description Power off Running Sleeping ✏ NOTE The colors listed in Table 32 and Table 33 are suggested colors only. Actual LED colors are product- or customer-specific. 2.8.2.4.4 Power Switch Connector [Red] Pins 6 and 8 [Red] can be connected to a front panel momentary-contact power switch. The switch must pull the SW_ON# pin to ground for at least 50 ms to signal the power supply to switch on or off. (The time requirement is due to internal debounce circuitry on the board.) At least two seconds must pass before the power supply will recognize another on/off signal. 70